BarbL

should I redo it?

I'm reading the rest now. It never asked me to continue..it just did.

I honestly did not see it. I wasn't looking at it. There was a bar at the bottom and when I saw how long it was to go through, I just let it run. I never saw the screen you just showed me.

Yes Some of your instructions were not on my screen...I had to skip down a few. Or yours repeated.

It just ran through the process with different colors showing up on the screen. I don't remember that last link at all.

Warmer in the photo prints than on the computer. They print darker. I chose 'warm' for the color setting; perhaps it should have been something else.

Not yellow, just warmer. I guess I am not a good judge as to the brightness? I'm trying to look at grass, faces, clothing. All of it. The faces and grass/leaves are much warmer in my photos.

So, if I do not have that light that I need. What do I do? Of course, get the light...but now...the brightness on my screen is zero. I'm not sure where to go from here.

Whelp...not absolutely now.

Yes, I have pretty good light At my PC

Immediately I can tell that my photos are still a bit warmer. I could not seem to fix that with the brightness bar.

I never had to do all that before? Plus, I don't know how to use PS...and why I was attempting to calibrate so as to take your classes. Maybe I don't know enough to do that? It has calibrated. In the dark.

Ok, I am at Adjust Color Temperature Preset I do not know what to do. I honestly wish I knew how to send you a screen shot. Never mind. I see now all the above had been broken down. I just am to press 'next'. Geez

Seriously cannot copy the screen to you. I do not know how as it is not allowing me anymore. I'm stuck now...again.

My Gamma and White Point are the same as yours. Shall I change the Brightness and Room light to the same settings yours shows?

Yes

I'm sorry. Ever since my computer decided on it's OWN to switch to Windows 10, I'm lost. I can't screen shot...as I can't find the damn thing! Ok, click both then

I can try. It is the same screen you have in the instructions. Where it states Identify Controls.

Ok, so I picked the 'warm'...now, you say to Install my software, but I did that. Just didn't get through it. I was stuck at "Identify Controls"

It's roughly. I just went through the color as well. (Amazing, I could do that!) Eh, 'warm' was the closest. So, that is where it is set. Still, not perfect.

What throws me off is the color I think. They are all different. So, it seems they ALL need adjusted in some way or other.

Alright, I think the brightness is 'ok'. They are all different, so it was difficult.

This is quite difficult

Ok, now this is with how many photos? If I remember there was black and white and a couple other with bright colors?

Holy crap. If this is where I compare pictures in hand to the pictures on the monitor. It is BAD! Monitor is so much brighter and in hand is so dark! ew!