SX2D-10

[Damien Symonds]

< Go back to the previous step    << Go back to the beginning

Calibration Settings

At the left, make sure it's on "FullCAL".

Then turn your attention to the hub of the whole calibration operation:

1. "Gamma" can remain at 2.2, which is the worldwide standard.
2. Change the "White Point" to "6500K" (unless your lab advises otherwise).
3. Set the "Brightness" target to 80.
4. Turn "Room Light" off.
5. Set "Gray Balance Calibration" to "Better" unless you're in a dreadful hurry.

Then press the red "Next" button in the bottom right corner.

Monitor settings >>