Michelle Zeiss Posted November 9, 2019 Share Posted November 9, 2019 Hi Damien, I'm in the process of calibrating my MacBook Air using your instructions. I have included two screen shots of the results. The I'm not getting a white point reading nor a luminance reading. I've included the other screen shot just for more info. I don't want to go further with my prints until I get this straightened out. I appreciate your help. Thank you, Michelle Zeiss Link to comment Share on other sites More sharing options...
Damien Symonds Posted November 9, 2019 Share Posted November 9, 2019 Hi Michelle, have you still got the program open? Link to comment Share on other sites More sharing options...
Michelle Zeiss Posted November 9, 2019 Author Share Posted November 9, 2019 I’m out right now. Shoot. WhT should I do when I get home? Link to comment Share on other sites More sharing options...
Damien Symonds Posted November 9, 2019 Share Posted November 9, 2019 Never mind. How's the print comparison after calibration? Link to comment Share on other sites More sharing options...
Michelle Zeiss Posted November 9, 2019 Author Share Posted November 9, 2019 I will do it tomorrow and let you know. Link to comment Share on other sites More sharing options...
Michelle Zeiss Posted November 9, 2019 Author Share Posted November 9, 2019 I compared the prints to the monitor on my MacBook Air. I held the prints 90 degrees from the screen. The prints were darker as expected given that the screen is a light source as you say in the article. Other than that I think the color tones match pretty well. FYI, when I calibrated,I couldn't get it to the green area. It would either be just below or a little more above the green area. I went with the lower one that was at 90. What do you suggest? Link to comment Share on other sites More sharing options...
Damien Symonds Posted November 9, 2019 Share Posted November 9, 2019 Your screen MUST MATCH YOUR PRINTS. If your screen is too bright as you say, you have to calibrate again to a lower brightness level. Link to comment Share on other sites More sharing options...
Michelle Zeiss Posted November 10, 2019 Author Share Posted November 10, 2019 I have recalibrated and have adjusted the brightness on my screen to match the prints. Here is the reading. Link to comment Share on other sites More sharing options...
Damien Symonds Posted November 10, 2019 Share Posted November 10, 2019 Great! Are you satisfied with the match now? Link to comment Share on other sites More sharing options...
Michelle Zeiss Posted November 11, 2019 Author Share Posted November 11, 2019 Yes I am satisfied after adjusting the brightness. May I start the levels call? Link to comment Share on other sites More sharing options...
Damien Symonds Posted November 11, 2019 Share Posted November 11, 2019 I've emailed you. Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now