SX2E-10

[Damien Symonds]

< Go back to the previous step    << Go back to the beginning

Lights out

At this point, if you haven’t already, turn off the lights or pull the blinds, or whatever. You don’t need your calibration compromised by light sneaking in, so for your safest result, make your room as dark as possible.

Place the Spyder

Lengthen the cord, unclip the cover, then position the device as instructed:

Press "Continue".

Brightness

Your screen will change colours for a few seconds, then stop here:

Do as it says.  Flick to your settings window where your brightness slider is, and crank it all the way to maximum, then flick back and press "Continue".

(If you don't know how to flick, watch this video.)

A window of instructions will pop up. Read it if you need to, then press OK.

Then adjust your brightness slider back down, while watching the readings, to get as close as you can to the target:

(You'll notice that I wasn't able to hit the target exactly. I was aiming for 80, and the best I could do was 79.  That's completely okay.  Just get as close as you can.)

Then press "Continue" again.

Profiling >>