Warm prints

[Damien Symonds]

  On 5/18/2017 at 3:45 AM, S. Roberts said:

I read through the link. I don't think this is the problem. I noticed immediately when I installed the DVI cable and the monitor was reset. It was crazy bright and very blue. This does not happen when my monitor goes to sleep or when I get security alerts. It never happens.

Expand  

No no no!  Sorry, I didn't mean that.  I just mean that if the graphics card is loading slower than the Datacolor software, and thereby overriding the profile, as Datacolor suggested, then you can use that little app to re-over-ride it with the profile again.

But of course, that's only if you choose to re-activate the graphics card.

  On 5/18/2017 at 3:45 AM, S. Roberts said:

So, I've looked at these prints and feel that the colors are so similar. I notice small tone or shade differences, but no one else does, unless I go to great pains to point them out. Generally, the prints are a touch more yellow especially in whites, skin tones, and are a bit more - green (maybe) in the blacks. Pinks/reds/blues don't seem to be affected.

Should I move on to RAW?

Expand  

Yep.

[S. Roberts]

... where's the chillin' with a frosty beverage emoji? Lol.

Now to get on with turning my woeful images into masterpieces.

  On 5/18/2017 at 4:10 AM, Damien Symonds said:

you can use that little app to re-over-ride it with the profile again.

Expand  

Got it! Thank you, Damien.