Damien Symonds

No, you're in the right place. Go to "Home" then scroll down to the Classes section.

Do not post until you have read the new content.

The skin is not really the problem here. We need to talk about this in the Raw Class please.

http://mbf.cc/W2Vlpv

Not next time. This time. Start over. With a big slap upside your own head for good measure. For heaven's sake don't let this happen again - do THIS.

Yeah, one board might be enough?

Next, this.

Good. So there is no actual problem with the file, apart from the fact that you have neglected the noise removal. Please never neglect that, ever. Please do it now, then tell me if the "problem" still exists when you open the file into Photoshop.

We need to be very clear about this ... ... or no difference at all? It's most likely that they're identical between ACR and PS when both are viewed at 100%. But I need you to confirm that before we move on to the next part of the discussion.

Thanks. Now could you zoom in to 100% on the file in ACR, and take a screenshot to show me how it differs there? This is only half of the recommended minimum RAM for CS6. You're likely to have problems.

First things first, please don't halve your hard drive space and computer power by working in 16-bit. It's completely unnecessary. Secondly, please show me a 100% crop of the grain in Photoshop. Thirdly, fill this out for me.

May we see a screenshot of that?

I figure maybe it will be necessary to add some floor to the right-hand side, at least? What are your thoughts?

By the way, have you seen this one? http://www.damiensymonds.net/demonstration-extending-studio-floor-backdrop-photoshop.html

No, it's ok, let's just talk it through. My first question is - do you think you'll need to extend the flooring either side also? Or can you crop it close enough to prevent that necessity?

Yes, of course. "Dumb" programs like that aren't colour-managed, so they must never be used.

The most common cause is if you forgot this: http://www.damiensymonds.net/wp-content/uploads/2015/12/06s5elite02-1.gif

Oversaturated in Photoshop, do you mean, or in other programs?

Hi Glynda, can you do this for me?

Try adding a Levels layer, and move the middle slider on each of the three channels: Red channel 2.50 Green channel 1.50 Blue channel 1.35 Then invert the mask and paint on gently where needed.

Sorry, no "tricks" here. Just very patient cloning.

May we see a 100% crop of the lines?

Yeah, we need to know if that works ok. It'll give us some clues about the problem.

Right, because when I write articles about sharpening, they're about sharpening. When sharpening happens, I mean. At the end of the workflow.

I talk about this at great length in the class.